AH30 - DIP Switch Configuration Table (S101)
| DIP SWITCH NUMBER | LABEL | DESCRIPTION |
|---|---|---|
| 1-5 | A0-A4 |
Controls RS485 addressing BIT 0-BIT 4. ON => Address bit set. OFF => Address bit NOT set. See AH30 - RS485 Addressing Reference on page 13. |
| 6 | DOWN |
Controls use of RS485 pull down resistor. ON => 620 Ohm pull down connected/enabled. OFF => 620 Ohm pull down disconnected/disabled. |
| 7 | UP |
Controls use of RS485 and pull up resistor. ON =>620 Ohm pull up connected/enabled. OFF => 620 Ohm pull up disconnected/disabled. |
| 8 | TERM |
Controls use of termination resistor between RS485 A and RS485 B. ON =>100 Ohm termination resistor connected/ enabled. OFF => 100 Ohm termination resistor disconnected/ disabled. |
| 9 | Not used. | |
| 10 | INT/EXT |
Controls use of external antenna if required. ON =>Selects use of internal antenna. OFF => Selects use of external antenna. |